Skip to content
Protocolos
Compounds › Repair and tissue

TB-500

Fragment of thymosin beta-4 — cell migration

Not approvedRepair and tissue

Experimental material. Read before using anything from here.

Nothing on this page is a medical recommendation, prescription or treatment plan. It is an organized translation of protocols circulating in research communities and, where it exists, of what published trials tested. The two are marked differently — and they are not equivalent.

Most of the compounds here have no FDA approval for human use. Several are sold labeled "research use only", which means they have not gone through purity, sterility or dosage controls for human consumption. A community-reported dose is not a validated dose: it is what someone reported having done.

Talk to a licensed health professional before considering any of these compounds. If you already use one and feel anything unexpected, seek care — do not wait for the next routine test.

Summary

Synthetic 7-amino-acid fragment of thymosin beta-4, a larger peptide present throughout the body. The sequence is Ac-LKKTETQ, corresponding to amino acids 17–23 of Tβ4. The 'Ac' prefix indicates acetylation at one end. Interest lies in cell migration and systemic repair, rather than local repair like BPC-157.

Quick reference

Route
Subcutaneous in most protocols. Some animal studies use IM or intraperitoneal.
Concentration
10 mg vial + 2 mL of bacteriostatic water = 5 mg/mL. On the U-100, 10 units = 0.10 mL ≈ 500 mcg.
Schedule
Loading phase (2×/week) followed by maintenance (1×/week).
Cycle
4–12 weeks. Long maintenance phases are discussed less consistently.

Dosing patterns

Dosing patterns
PhaseWeekly amountFrequencyDuration
Loading~4-5 mg/week2x per weekWeeks 1-6
Maintenance~2-2.5 mg/week1×/weekWeeks 7-12
Off period0 mgNone4–8 weeks

Dosing patterns

Dosing patterns
PhasePer-dose amountFrequencyDuration
Front-loading~2-2.5 mgEvery 2-3 daysWeeks 1-2
Taper~2-2.5 mg1×/weekWeeks 3-8

Cycle Guidelines

Cycle Guidelines
ApproachDurationOff periodBest for
Short cycle4-6 weeks4 weeksSingle research-question focus
Standard cycle8–12 weeks4–8 weeksMost community-referenced plans
Maintenance after load1×/week, 6–12 weeksVariableContinuation after a 4-6 week loading phase

TB-500 Reconstitution Guide

TB-500 Reconstitution Guide
Vial sizeBAC water addedConcentration10 unit draw100 unit draw
10 mg2.0 mL5.0 mg/mL0.10 mL = 500 mcg0.50 mL = 2.5 mg
10 mg3.0 mL3.33 mg/mL0.10 mL = 333 mcg0.75 mL = 2.5 mg

TB-500 vs BPC-157

TB-500 vs BPC-157
ReferenceTB-500Thymosin beta-4 (full)BPC-157
Length7 amino acids43 amino acids15 amino acids
SourceSynthetic fragmentEndogenous peptideSynthetic, derived from gastric juice
Primary mechanism referenceActin binding (fragment)Actin sequestration; broader signalingGrowth factor / angiogenic / cytoprotective signaling
Strongest human evidenceNone for the fragment specificallyPhase 2 wound, Phase 3 ocular (topical)Small open-label and case series for joint pain
FDA statusNot approved; PCAC review on July 23, 2026Not approved; investigational in topical/ophthalmic formulationsNot approved; PCAC review on July 23, 2026
WADA statusProhibited (S0)Prohibited (S0)Prohibited (S0)

Storage and handling

The rules below apply to practically every lyophilized peptide in this reference. Where a compound has its own requirement, it appears in the table in the previous section.

  • Lyophilized powder, sealed: refrigerator, between 2 and 8 °C, protected from light. Many tolerate room temperature for short transport periods, but that is tolerance, not a recommendation.
  • After reconstitution: always refrigerated, between 2 and 8 °C. The stability window drops to days or a few weeks, depending on the compound.
  • Never freeze after reconstituting. The freeze–thaw cycle degrades the peptide.
  • Do not shake. Swirl the vial slowly. Shaking breaks the peptide chain.
  • Bacteriostatic water down the wall of the vial, in a slow stream, not squirted directly onto the powder.
  • Cloudy solution, with particles or a color change: discard. There is no recovery.

Lab tests and monitoring

This list is the one that appears recurrently in the source, with small variations by compound. It serves as a starting point for a conversation with a professional — not as a substitute for that conversation.

  • Before starting: complete blood count, comprehensive metabolic panel, lipid panel, fasting glucose and HbA1c, TSH and free T4, blood pressure and resting heart rate.
  • Depending on the compound: IGF-1 (GH axis), lipase and amylase (VIP and the incretin agonists), serum copper and ceruloplasmin (GHK-Cu and blends containing it), CRP.
  • Reassessment: most protocols review between week 4 and week 8, and then every 8–12 weeks.
  • Do not wait for the routine lab test in the face of abdominal pain, visual changes, a change in a mole, shortness of breath, asymmetric swelling or any new and persistent symptom. That is a reason to seek care, not a spreadsheet item.

Evidence limits

What these numbers are and what they are not. The values above were preserved exactly as they appear in the source, without reinterpretation. What the source describes as community practice is marked as such in the tables; what came from a published trial is too. A dose repeated by many people does not become a validated dose by repetition.

Data source: peptidedosingprotocols.com, accessed on September 3, 2026. Translation and organization in Portuguese are original work. No primary source (PubMed, trial registry, package insert) was checked in building this page — the check was against the secondary source, and that alone.

← Back to all compounds